Step 1 : Mount the side panel into its corresponding slots at a forward-leaning angle to facilitate smoother insertion of the Lexan shield. Step 2 : Align the Lexan shield with the grooves on both side panels, slide it in gently, and push down until it reaches the base plate and can’t go any further. Step 3 : Next, rotate the two side panels along with the Lexan shield toward the back, aligning them fully with the grooves on the base plate. Apply pressure to ensure all components are securely and completely inserted. Step 4 : Insert the mesh back panel into the designated gap at the rear of the base plate. Press it down firmly until it is level with the side panels. Step 5 : You are now ready to lower the launch monitor into the protective case in its designated support on the base plate. Step 6 : Similar to the installation of the side panels earlier, align the top cover at an angle and secure it into its grooves with the side panels rotated back. Press down firmly to ensure the cover is fully inserted and level. Step 7 : Install the leveling feet and adjust them according to your setup, using the leveling bubble on the top cover as a guide and Enjoy! :)

The Protective shield is made of polycarbonate ( Lexan) 4.5mm thick